SnowLoadCheck

Andrews County, TX Roof Snow Load - 5 psf

What ASCE 7 says about snow load in Andrews County

Light
5 psf

That's Andrews County's design roof snow load per ASCE 7-22, for a typical heated single-family home - the number a permit reviewer starts from. Flat and low-pitch roofs in Andrews County are actually governed by ASCE 7's §7.3.4 minimum of 5 psf, not the 3.5 psf the ground-load formula alone would produce.

Converted to something you can actually eyeball on a roof: about 11 in. of fresh powder, 4 in. once it settles and packs down, or just 1 in. if it's turned to ice. A modest addition to standard roof loading. Ordinary residential construction handles this without extra bracing.

Andrews County in numbers

Where Andrews County's figure sits nationally

Out of 2,758 rated US counties, Andrews County sits at #2,307, the top 84% nationally - #135 of 254 within Texas. 5.4 psf is Texas's typical county figure - Andrews County comes in 0.4 psf under it.

Near 32.3123°N 102.6402°W, FIPS 48003: Andrews County counts 18,923 residents and a 5 psf map value, which the code's own factors turn into 5 psf.

How much it actually snows in Andrews County

Most winters bring Andrews County roughly 1.9 in. of snow - NOAA's normal at JAL, NM US, 34.9 mi off. That station is far enough away (34.9 mi) that local snowfall - especially at a different elevation or near a lake - can run noticeably higher or lower than this figure. (fresh vs. packed vs. ice explains why.)

Read this before you rely on it

Andrews County's number above is ASCE 7-22's default case, not a custom calculation: ordinary residential occupancy, heated, sited on ground that's neither fully sheltered nor fully exposed. Any one of those changing - pitch, exposure, heating, occupancy - moves the real figure.

Nothing here substitutes for an address-level number. Get one free, in about a minute, from the ASCE 7 Hazard Tool using your own coordinates rather than Andrews County's county-wide figure. (How this figure is calculated.)