SnowLoadCheck

Bradley County, AR Roof Snow Load - 10 psf

What ASCE 7 says about snow load in Bradley County

Light
10 psf

That's Bradley County's design roof snow load per ASCE 7-22, for a typical heated single-family home - the number a permit reviewer starts from. The physics-based figure alone would be 7 psf, but ASCE 7's own low-slope minimum (§7.3.4) sets a floor of 10 psf for flat and low-pitch roofs here, which is the number that actually governs.

Converted to something you can actually eyeball on a roof: about 22 in. of fresh powder, 8 in. once it settles and packs down, or just 2 in. if it's turned to ice. Standard residential construction handles a load this size without extra bracing; it is a modest addition on top of ordinary roof loading.

Already snow on the roof in Bradley County?

in. of

Bradley County in numbers

Where Bradley County's figure sits nationally

Out of 2,758 rated US counties, Bradley County sits at #2,000, the top 73% nationally - #57 of 75 within Arkansas. That's 0.1 psf below Arkansas's own county-average design load of 10.1 psf.

Near 33.4665°N 92.1692°W, FIPS 05011: Bradley County counts 9,935 residents and a 10 psf map value, which the code's own factors turn into 10 psf.

How much it actually snows in Bradley County

Most winters bring Bradley County roughly 1.5 in. of snow - NOAA's normal at WARREN 2 WSW, AR US, 10.3 mi off. (fresh vs. packed vs. ice explains why.)

Read this before you rely on it

Bradley County's number above is ASCE 7-22's default case, not a custom calculation: ordinary residential occupancy, heated, sited on ground that's neither fully sheltered nor fully exposed. Any one of those changing - pitch, exposure, heating, occupancy - moves the real figure.

Nothing here substitutes for an address-level number. Get one free, in about a minute, from the ASCE 7 Hazard Tool using your own coordinates rather than Bradley County's county-wide figure. (How this figure is calculated.)