SnowLoadCheck

Burlington County, NJ Roof Snow Load - 20 psf

How much snow is too much for a roof in Burlington County, NJ?

Moderate
20 psf

20 psf: that's what ASCE 7-22 requires a typical heated home's roof in Burlington County to carry. The physics-based figure alone would be 14 psf, but ASCE 7's own low-slope minimum (§7.3.4) sets a floor of 20 psf for flat and low-pitch roofs here, which is the number that actually governs.

Picture it, not just weigh it: 44 in. if it's fresh powder, 16 in. once it settles, or a mere 4 in. if it's ice. A meaningful design load. Most homes built to modern code handle it, but additions, carports, and flat-roofed sections are worth a second look.

Burlington County at a glance

How Burlington County compares

20 psf ranks #546 of 2,758 US counties with a mapped snow load (top 20%) - and #11 of 17 in New Jersey. That's 0.1 psf below New Jersey's own county-average design load of 20.1 psf.

Population 475,515 (FIPS 34005), roughly 39.8758°N 74.663°W. The 20 psf ground snow load ASCE 7-22 maps here becomes 20 psf once the code's own design factors are applied.

Typical snowfall in Burlington County, NJ

NOAA's 30-year normal for Burlington County: 24.8 in. of snow a year, from the PHILADELPHIA/MT HOLLY WFO, NJ US station. (fresh vs. packed vs. ice explains why.)

What this Burlington County figure assumes

This is a county-level reference figure for a typical heated home built to Risk Category II (ordinary residential), on a partially exposed lot - the assumptions ASCE 7-22 itself treats as the default case. A steeper roof, a fully exposed hilltop lot, an unheated structure, or a higher risk category all change the actual number.

Burlington County's permit office wants an address-specific figure, not this county average - the ASCE 7 Hazard Tool is free, takes under a minute, and outputs a PDF most reviewers accept. See the methodology guide.