SnowLoadCheck

Collingsworth County, TX Roof Snow Load - 15 psf

Collingsworth County, TX roof snow load, translated

Moderate
15 psf

A typical heated home in Collingsworth County is designed to carry 15 pounds per square foot of snow on its roof, per ASCE 7-22. The physics-based figure alone would be 10.5 psf, but ASCE 7's own low-slope minimum (§7.3.4) sets a floor of 15 psf for flat and low-pitch roofs here, which is the number that actually governs.

On a roof that means 33 in. of fresh snow, 12 in. once it packs down, or 3 in. of solid ice - three very different piles for the same load. This is a meaningful design load - most modern-code homes handle it fine, though an addition, a carport or a flat-roofed section can be a weak spot.

Collingsworth County, TX: quick facts

Where Collingsworth County ranks

#25 of 254 Texas counties by design load, top 59% of 2,758 nationally - that's Collingsworth County's spot. Texas counties average 5.4 psf; Collingsworth County runs 9.6 psf higher than that.

FIPS 48087, population 2,611, centered near 34.9634°N 100.2721°W. ASCE 7's underlying ground snow load here is 15 psf before the code's exposure and importance factors bring it to the 15 psf design figure above.

Collingsworth County: average annual snowfall

Collingsworth County sees about 4 in. of snow most winters, per the WELLINGTON, TX US station's 1991-2020 NOAA normal. See the density guide.

Read this before you use Collingsworth County's figure

The figure above assumes the case ASCE 7-22 treats as typical: a heated, ordinary-occupancy home on a partially exposed site. Change any of those - exposure, heating, roof pitch, occupancy category - and the real design number moves.

A building permit needs the number at your exact address, not the county average - the free ASCE 7 Hazard Tool returns that from your coordinates in about a minute and produces a PDF a plan reviewer will accept. (How this figure is calculated.)