Hopkins County, TX Roof Snow Load - 5 psf
How much snow is too much for a roof in Hopkins County, TX?
5 psf: that's what ASCE 7-22 requires a typical heated home's roof in Hopkins County to carry. The physics-based figure alone would be 3.5 psf, but ASCE 7's own low-slope minimum (§7.3.4) sets a floor of 5 psf for flat and low-pitch roofs here, which is the number that actually governs.
Picture it, not just weigh it: 11 in. if it's fresh powder, 4 in. once it settles, or a mere 1 in. if it's ice. This is a modest add-on to standard roof loading - ordinary residential construction carries it without extra bracing.
Hopkins County in numbers
- Design roof snow load5 psf
- Ground snow load, ASCE 7 map5 psf
- National rank#2,210 of 2,758
- Texas rank#99 of 254
- Population38,784
- Annual snowfall, NOAA normal0.4 in.
- FIPS48223
How Hopkins County compares
5 psf ranks #2,210 of 2,758 US counties with a mapped snow load (top 80%) - and #99 of 254 in Texas. That's 0.4 psf below Texas's own county-average design load of 5.4 psf.
Population 38,784 (FIPS 48223), roughly 33.149°N 95.5654°W. The 5 psf ground snow load ASCE 7-22 maps here becomes 5 psf once the code's own design factors are applied.
Typical snowfall in Hopkins County, TX
NOAA's 30-year normal for Hopkins County: 0.4 in. of snow a year, from the WINNSBORO 5 NNE, TX US station. (fresh vs. packed vs. ice explains why.)
What this Hopkins County figure assumes
This is a county-level reference figure for a typical heated home built to Risk Category II (ordinary residential), on a partially exposed lot - the assumptions ASCE 7-22 itself treats as the default case. A steeper roof, a fully exposed hilltop lot, an unheated structure, or a higher risk category all change the actual number.
Hopkins County's permit office wants an address-specific figure, not this county average - the ASCE 7 Hazard Tool is free, takes under a minute, and outputs a PDF most reviewers accept. Details: the calculation guide.