Kendall County, TX Roof Snow Load - 5 psf
Kendall County, TX roof snow load, translated
A typical heated home in Kendall County is designed to carry 5 pounds per square foot of snow on its roof, per ASCE 7-22. The physics-based figure alone would be 3.5 psf, but ASCE 7's own low-slope minimum (§7.3.4) sets a floor of 5 psf for flat and low-pitch roofs here, which is the number that actually governs.
On a roof that means 11 in. of fresh snow, 4 in. once it packs down, or 1 in. of solid ice - three very different piles for the same load. A modest addition to standard roof loading. Ordinary residential construction handles this without extra bracing.
Snow on Kendall County's roofs right now?
Kendall County in numbers
- Design roof snow load5 psf
- Ground snow load, ASCE 7 map5 psf
- National rank#2,191 of 2,758
- Texas rank#93 of 254
- Population51,828
- Annual snowfall, NOAA normal0.2 in.
- FIPS48259
Where Kendall County ranks
#93 of 254 Texas counties by design load, top 79% of 2,758 nationally - that's Kendall County's spot. Texas counties average 5.4 psf; Kendall County runs 0.4 psf lower than that.
FIPS 48259, population 51,828, centered near 29.9435°N 98.7093°W. ASCE 7's underlying ground snow load here is 5 psf before the code's exposure and importance factors bring it to the 5 psf design figure above.
Kendall County: average annual snowfall
Kendall County sees about 0.2 in. of snow most winters, per the SISTERDALE 2SE, TX US station's 1991-2020 NOAA normal. See the density guide.
Read this before you use Kendall County's figure
The figure above assumes the case ASCE 7-22 treats as typical: a heated, ordinary-occupancy home on a partially exposed site. Change any of those - exposure, heating, roof pitch, occupancy category - and the real design number moves.
A building permit needs the number at your exact address, not the county average - the free ASCE 7 Hazard Tool returns that from your coordinates in about a minute and produces a PDF a plan reviewer will accept. (How this figure is calculated.)