SnowLoadCheck

Knox County, TX Roof Snow Load - 5 psf

How much snow is too much for a roof in Knox County, TX?

Light
5 psf

5 psf: that's what ASCE 7-22 requires a typical heated home's roof in Knox County to carry. 3.5 psf is what the ground-load formula alone gives; Knox County's 5 psf low-slope minimum (§7.3.4) beats it, so that figure is the one that governs on flat and low-pitch roofs.

Picture it, not just weigh it: 11 in. if it's fresh powder, 4 in. once it settles, or a mere 1 in. if it's ice. This is a modest add-on to standard roof loading - ordinary residential construction carries it without extra bracing.

Knox County, TX: quick facts

How Knox County compares

5 psf ranks #2,447 of 2,758 US counties with a mapped snow load (top 89%) - and #190 of 254 in Texas. That's 0.4 psf below Texas's own county-average design load of 5.4 psf.

Population 3,255 (FIPS 48275), roughly 33.6119°N 99.7304°W. The 5 psf ground snow load ASCE 7-22 maps here becomes 5 psf once the code's own design factors are applied.

Typical snowfall in Knox County, TX

NOAA's 30-year normal for Knox County: 1.2 in. of snow a year, from the TRUSCOTT 3 W, TX US station. (fresh vs. packed vs. ice explains why.)

What this Knox County figure assumes

This is a county-level reference figure for a typical heated home built to Risk Category II (ordinary residential), on a partially exposed lot - the assumptions ASCE 7-22 itself treats as the default case. A steeper roof, a fully exposed hilltop lot, an unheated structure, or a higher risk category all change the actual number.

Knox County's permit office wants an address-specific figure, not this county average - the ASCE 7 Hazard Tool is free, takes under a minute, and outputs a PDF most reviewers accept. (How this figure is calculated.)