SnowLoadCheck

Montague County, TX Roof Snow Load - 5 psf

What ASCE 7 says about snow load in Montague County

Light
5 psf

That's Montague County's design roof snow load per ASCE 7-22, for a typical heated single-family home - the number a permit reviewer starts from. The physics-based figure alone would be 3.5 psf, but ASCE 7's own low-slope minimum (§7.3.4) sets a floor of 5 psf for flat and low-pitch roofs here, which is the number that actually governs.

Converted to something you can actually eyeball on a roof: about 11 in. of fresh powder, 4 in. once it settles and packs down, or just 1 in. if it's turned to ice. This is a modest add-on to standard roof loading - ordinary residential construction carries it without extra bracing.

Montague County in numbers

Where Montague County's figure sits nationally

Out of 2,758 rated US counties, Montague County sits at #2,280, the top 83% nationally - #124 of 254 within Texas. 5.4 psf is Texas's typical county figure - Montague County comes in 0.4 psf under it.

Near 33.6784°N 97.725°W, FIPS 48337: Montague County counts 21,890 residents and a 5 psf map value, which the code's own factors turn into 5 psf.

How much it actually snows in Montague County

Most winters bring Montague County roughly 0.1 in. of snow - NOAA's normal at FORESTBURG 5 S, TX US, 16.9 mi off. (fresh vs. packed vs. ice explains why.)

Read this before you rely on it

Montague County's number above is ASCE 7-22's default case, not a custom calculation: ordinary residential occupancy, heated, sited on ground that's neither fully sheltered nor fully exposed. Any one of those changing - pitch, exposure, heating, occupancy - moves the real figure.

Nothing here substitutes for an address-level number. Get one free, in about a minute, from the ASCE 7 Hazard Tool using your own coordinates rather than Montague County's county-wide figure. Details: the calculation guide.