SnowLoadCheck

Nolan County, TX Roof Snow Load - 5 psf

What ASCE 7 says about snow load in Nolan County

Light
5 psf

That's Nolan County's design roof snow load per ASCE 7-22, for a typical heated single-family home - the number a permit reviewer starts from. 3.5 psf is what the ground-load formula alone gives; Nolan County's 5 psf low-slope minimum (§7.3.4) beats it, so that figure is the one that governs on flat and low-pitch roofs.

Converted to something you can actually eyeball on a roof: about 11 in. of fresh powder, 4 in. once it settles and packs down, or just 1 in. if it's turned to ice. A modest addition to standard roof loading. Ordinary residential construction handles this without extra bracing.

Nolan County at a glance

Where Nolan County's figure sits nationally

Out of 2,758 rated US counties, Nolan County sits at #2,345, the top 85% nationally - #148 of 254 within Texas. That's 0.4 psf below Texas's own county-average design load of 5.4 psf.

Near 32.3123°N 100.4181°W, FIPS 48353: Nolan County counts 14,182 residents and a 5 psf map value, which the code's own factors turn into 5 psf.

How much it actually snows in Nolan County

Most winters bring Nolan County roughly 0.5 in. of snow - NOAA's normal at OAK CREEK LAKE, TX US, 20.4 mi off. (fresh vs. packed vs. ice explains why.)

Read this before you rely on it

Nolan County's number above is ASCE 7-22's default case, not a custom calculation: ordinary residential occupancy, heated, sited on ground that's neither fully sheltered nor fully exposed. Any one of those changing - pitch, exposure, heating, occupancy - moves the real figure.

Nothing here substitutes for an address-level number. Get one free, in about a minute, from the ASCE 7 Hazard Tool using your own coordinates rather than Nolan County's county-wide figure. (How this figure is calculated.)