SnowLoadCheck

Pike County, OH Roof Snow Load - 20 psf

What ASCE 7 says about snow load in Pike County

Moderate
20 psf

That's Pike County's design roof snow load per ASCE 7-22, for a typical heated single-family home - the number a permit reviewer starts from. 14 psf is what the ground-load formula alone gives; Pike County's 20 psf low-slope minimum (§7.3.4) beats it, so that figure is the one that governs on flat and low-pitch roofs.

Converted to something you can actually eyeball on a roof: about 44 in. of fresh powder, 16 in. once it settles and packs down, or just 4 in. if it's turned to ice. This is a meaningful design load - most modern-code homes handle it fine, though an addition, a carport or a flat-roofed section can be a weak spot.

Already snow on the roof in Pike County?

in. of

Pike County in numbers

Where Pike County's figure sits nationally

Out of 2,758 rated US counties, Pike County sits at #892, the top 32% nationally - #77 of 86 within Ohio. Pike County's figure lands almost exactly on Ohio's own county-average of 20 psf.

Near 39.0713°N 83.0529°W, FIPS 39131: Pike County counts 27,065 residents and a 20 psf map value, which the code's own factors turn into 20 psf.

How much it actually snows in Pike County

Most winters bring Pike County roughly 11.5 in. of snow - NOAA's normal at WAVERLY, OH US, 4.8 mi off. (fresh vs. packed vs. ice explains why.)

Read this before you rely on it

Pike County's number above is ASCE 7-22's default case, not a custom calculation: ordinary residential occupancy, heated, sited on ground that's neither fully sheltered nor fully exposed. Any one of those changing - pitch, exposure, heating, occupancy - moves the real figure.

Nothing here substitutes for an address-level number. Get one free, in about a minute, from the ASCE 7 Hazard Tool using your own coordinates rather than Pike County's county-wide figure. (How this figure is calculated.)