SnowLoadCheck

San Augustine County, TX Roof Snow Load - 5 psf

What ASCE 7 says about snow load in San Augustine County

Light
5 psf

That's San Augustine County's design roof snow load per ASCE 7-22, for a typical heated single-family home - the number a permit reviewer starts from. The physics-based figure alone would be 3.5 psf, but ASCE 7's own low-slope minimum (§7.3.4) sets a floor of 5 psf for flat and low-pitch roofs here, which is the number that actually governs.

Converted to something you can actually eyeball on a roof: about 11 in. of fresh powder, 4 in. once it settles and packs down, or just 1 in. if it's turned to ice. Standard residential construction handles a load this size without extra bracing; it is a modest addition on top of ordinary roof loading.

San Augustine County in numbers

Where San Augustine County's figure sits nationally

Out of 2,758 rated US counties, San Augustine County sits at #2,408, the top 87% nationally - #172 of 254 within Texas. Texas counties average 5.4 psf; San Augustine County runs 0.4 psf lower than that.

Near 31.3824°N 94.1632°W, FIPS 48405: San Augustine County counts 7,767 residents and a 5 psf map value, which the code's own factors turn into 5 psf.

How much it actually snows in San Augustine County

Most winters bring San Augustine County roughly 0.1 in. of snow - NOAA's normal at BROADDUS, TX US, 8.3 mi off. (fresh vs. packed vs. ice explains why.)

Read this before you rely on it

San Augustine County's number above is ASCE 7-22's default case, not a custom calculation: ordinary residential occupancy, heated, sited on ground that's neither fully sheltered nor fully exposed. Any one of those changing - pitch, exposure, heating, occupancy - moves the real figure.

Nothing here substitutes for an address-level number. Get one free, in about a minute, from the ASCE 7 Hazard Tool using your own coordinates rather than San Augustine County's county-wide figure. (How this figure is calculated.)