SnowLoadCheck

Shelby County, IN Roof Snow Load - 20 psf

What ASCE 7 says about snow load in Shelby County

Moderate
20 psf

That's Shelby County's design roof snow load per ASCE 7-22, for a typical heated single-family home - the number a permit reviewer starts from. ASCE 7's low-slope-roof minimum (§7.3.4) raises the governing figure to 20 psf - higher than the 14 psf the ground-load formula alone would give, and the code says use the larger one.

Converted to something you can actually eyeball on a roof: about 44 in. of fresh powder, 16 in. once it settles and packs down, or just 4 in. if it's turned to ice. This is a meaningful design load - most modern-code homes handle it fine, though an addition, a carport or a flat-roofed section can be a weak spot.

Shelby County, IN: quick facts

Where Shelby County's figure sits nationally

Out of 2,758 rated US counties, Shelby County sits at #755, the top 27% nationally - #26 of 89 within Indiana. That's 0.7 psf above Indiana's own county-average design load of 19.3 psf.

Near 39.5241°N 85.7922°W, FIPS 18145: Shelby County counts 45,654 residents and a 20 psf map value, which the code's own factors turn into 20 psf.

How much it actually snows in Shelby County

Most winters bring Shelby County roughly 14.6 in. of snow - NOAA's normal at SHELBYVILLE SEWAGE PLT, IN US, 0.3 mi off. (fresh vs. packed vs. ice explains why.)

Read this before you rely on it

Shelby County's number above is ASCE 7-22's default case, not a custom calculation: ordinary residential occupancy, heated, sited on ground that's neither fully sheltered nor fully exposed. Any one of those changing - pitch, exposure, heating, occupancy - moves the real figure.

Nothing here substitutes for an address-level number. Get one free, in about a minute, from the ASCE 7 Hazard Tool using your own coordinates rather than Shelby County's county-wide figure. See the methodology guide.