Tyler County, TX Roof Snow Load - 5 psf
What ASCE 7 says about snow load in Tyler County
That's Tyler County's design roof snow load per ASCE 7-22, for a typical heated single-family home - the number a permit reviewer starts from. The physics-based figure alone would be 3.5 psf, but ASCE 7's own low-slope minimum (§7.3.4) sets a floor of 5 psf for flat and low-pitch roofs here, which is the number that actually governs.
Converted to something you can actually eyeball on a roof: about 11 in. of fresh powder, 4 in. once it settles and packs down, or just 1 in. if it's turned to ice. This is a modest add-on to standard roof loading - ordinary residential construction carries it without extra bracing.
Tyler County in numbers
- Design roof snow load5 psf
- Ground snow load, ASCE 7 map5 psf
- National rank#2,294 of 2,758
- Texas rank#129 of 254
- Population20,560
- Annual snowfall, NOAA normal0.3 in.
- FIPS48457
Where Tyler County's figure sits nationally
Out of 2,758 rated US counties, Tyler County sits at #2,294, the top 83% nationally - #129 of 254 within Texas. Texas counties average 5.4 psf; Tyler County runs 0.4 psf lower than that.
Near 30.7693°N 94.3757°W, FIPS 48457: Tyler County counts 20,560 residents and a 5 psf map value, which the code's own factors turn into 5 psf.
How much it actually snows in Tyler County
Most winters bring Tyler County roughly 0.3 in. of snow - NOAA's normal at WOODVILLE, TX US, 2.1 mi off. (fresh vs. packed vs. ice explains why.)
Read this before you rely on it
Tyler County's number above is ASCE 7-22's default case, not a custom calculation: ordinary residential occupancy, heated, sited on ground that's neither fully sheltered nor fully exposed. Any one of those changing - pitch, exposure, heating, occupancy - moves the real figure.
Nothing here substitutes for an address-level number. Get one free, in about a minute, from the ASCE 7 Hazard Tool using your own coordinates rather than Tyler County's county-wide figure. Details: the calculation guide.